0 compression

Discussion in 'Mazdaspeed 3 Troubleshooting' started by B_boosting, Mar 31, 2020.

Watchers:
8 users.
Page 3 of 3
  1. B_boosting

    B_boosting Greenie Member

    Joined:
    Mar 31, 2020
    Posts:
    21
    Trophy Points:
    3
    Location:
    Florida
    Ratings:
    +3 / -6
    I’m with you on that. That’s why I’m going to be building my 2.3 block as soon as I drop it. I just need my daily back this Mazda 6 ain’t it lol, makes me feel like I’m 45
     
    B_boosting, via an iPhone, Apr 1, 2020
    #41
    • Like Like x 1
  2. udntknw

    udntknw Silver Member

    Joined:
    Feb 10, 2016
    Posts:
    96
    Trophy Points:
    18
    Location:
    Tucson, AZ
    Ratings:
    +49 / -1
    From what I've been reading, the 2.5 bottom swap is cheap and relatively easy. But, You are sacrificing the strength of the MZR DISI for a cheap bottom end. It'll get you back on the road, but I would use that purely as a crutch while the 2.3 gets rebuilt.
     
    udntknw, Apr 13, 2020
    #42
Page 3 of 3
Loading...
Similar Threads - compression
  1. Eldin

    Low compression all four cylinders

    Eldin, Jul 10, 2023, in forum: Mazdaspeed 3 Troubleshooting
    Replies:
    5
    Views:
    584
    Eldin
    Aug 5, 2023
  2. Riley Mayo

    Low compression on cylinder 3 65,000 miles

    Riley Mayo, Jul 25, 2022, in forum: Mazdaspeed 3/6 Engine
    Replies:
    11
    Views:
    1,717
    Cfoldone
    Jul 28, 2022
  3. TheAcumen

    Compression test

    TheAcumen, Jun 11, 2022, in forum: New Member Introduction Section
    Replies:
    4
    Views:
    71
    Easter Bunny
    Jun 12, 2022
  4. Imbenman

    Mod Options? Low-ish Compression

    Imbenman, Apr 20, 2022, in forum: Mazdaspeed 3 General Discussion
    Replies:
    7
    Views:
    639
    SyntheticAtmosphere
    Apr 21, 2022
  5. Rotormike

    Low compression on built motor tore up the cylinder walls

    Rotormike, Mar 31, 2022, in forum: Mazdaspeed 3/6 Engine
    Replies:
    8
    Views:
    1,126
    Rotormike
    Apr 19, 2022

Share This Page

Users Viewing Thread (Users: 0, Guests: 0)