I've gone ahead and contacted them, and have been offered a replacement. However, I've already installed a corksport RMM, so probably won't submit...
No, I never contacted CPE, but probably should have. I was uncertain if this was a structural failure at all, or more of an aesthetic issue, as...
Hi, just wanted to share a cautionary review of CP-E's rear motor mount for the Mazdaspeed3. I can't find my receipt for this part, but believe I...
Yep I'm reaaaaally hoping I don't have to take a hammer to it but there's so little room there that might be the only option. Do you know which...
Honestly most of the decision to run 245's come down to me hoping I can get away with not rolling the fenders. But if I do have to roll fenders to...
I daily it and will probably do 5-10 trackdays this summer. I've got 1/16" toe-in up front because it would wander a bit when I got on the...
That 2.5° is for better corner grip, pretty sure last year the outer edge of my tire wore through the quickest which is why I wanted to increase...
Again, just wanted to be on equal footing with similar cars, and am hoping slightly skinnier tires will require less modification to fit. But I...
This is a moog endlink from a (2007 ish?) Bmw m3, I've read of other people running KW v3's with them. But the moog design does have an area to...
Also just got some new wheels in! Still have to get tires mounted and see if I run into any fitment issues, decided to get 17x8.5 and 245 width...
Recently I've been getting a rubbing noise from the front driver side wheel well while turning left (moving or stationary.) So I got the car up...
[MEDIA]
Couldn't find any other threads on here about this. I've been getting a rubbing noise by the front driver side wheel while turning left, moving or...
Separate names with a comma.
