No part number for keyed crank for both Mazda and Ford Crank... they never came keyed in the factory and has to be custom machined by a shop,...
Ask the shop to replace the PCV valve, cost around $15-25 Located behind the Intake manifold [IMG] (I just reread your reply seems like you said...
-Custom Age 625+ 10mm (stock size) head studs torque to 100 lbs with ARP lube. -Cometic MLX Gasket (custom style with water jackets modified)...
search for the thread that had the VVT replacement, the instruction is actually there on how to do it, it doesnt show that the cams are remove but...
you can go on Freektune on the intruction with the headstuds, L19/H11 should be same and even the Custom Age 625+ pretty much all have the same...
what head gasket are you using? thickness? type? also what headstuds? and torque numbers?
is that ARP2000s head studs?
are you running SS oring with MLS?
Make sure for the ARP Headstuds, DO NOT get the ARP2000s go with -Custom Age 625+ -Freektune H11 -Edgeauto L19 theres a thread specifically...
you can directly email them and they will send you a installer for it. I did email them saying almost 90% of laptops and computer doesn't have a...
Check you crank position sensor, the pigtail(connector) should be facing inside towards the engine. some people install it back wars since its...
N/A 2.3 from the older mazda3/6 and the 2.5L from fusions and new mazda do have a stronger chain, and thicker gears, just google the chain, sp63...
can you check what is you vacuum level when it get stiff
looks like you popped a charge pipe with that 31 psi pull,
Huge props to you for actually tackling this, and also in your GARAGE and with just jack stands! by any chance can you elaborate on the controller...
M10x1.50 AFAIR
Factory spec for original crank bolt wheter youre keyed or not if its factory bolt you are using its 76 ft/lbs + 93 degrees= around 280ish when my...
Just to clarifiy, the timing wheel "teeth plate" is snapped on to the pulley, you can take a flat head screw driver and pry it off, it is not...
check the coil pack ground wire, its in the bracket where the two main harness is bolted down[IMG]
KYB is the facory shocks for the 6
Separate names with a comma.