I took my block to the machine shop for them to inspect the lower chip. When the shop owner inspected it he said that there will not be a problem...
I have got Manley Hbeam rods, Mahle 4032 pistons,king main and rod bearings, arp main studs. Hoping that the machine shop will have some good...
Thanks for the reply. I will take everything to the machine shop and keep my fingers crossed.
Hello everyone, I have just taken apart my engine rod find out that I have a bent rod and a small chip on the bottom to the bore. should I be...
In cylinder number 1 with the cracked piston was sitting low in the cylinder so I assume that the bearings have spun. I do not know the situation...
I did not replace the piston because of time. I had the gen 1 motor so I just that bottom end put the rebuild head on it and have intentions of...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Approximately 700 miles since assembly. About 1qt per 200 miles The picture of the engine...
Hey guys, I have a question for you. I have a 2007 Mazdaspeed 3 that had a motor that pistons hit the valves. This is what I have done. First of...
Update. The engine had a cracked piston #1
Hey guys can someone with a good ear tell me what would be rattling i my engine. Just the timing Chain and a new Vvt. Thought that was the...
I was not sure if I had to loosen the cam sprocket and the Vvt while putting on the new chain. But I did order new washers just in case. My plan...
I have a 2007 mazdaspeed 3 and did a motor replacement on the car with a gen2 2013 motor with a about 160000kms on the engine (100000 miles). The...
Is this to much play with the timing chain off. Thanks
I have question about the Vvt. I am replacing the timing chain and noticed that I have movement in the Vvt. Is this normal? Thanks for your help!!!
Separate names with a comma.