Total Noob Seeking Tune Help

2008 MS3, HPFP upgrade, COBB intake and downpipe, Stock turbo went bad, Installed; CS CST5 turbo, 4" intake, EBCS, 3.5bar MAP, Garrett FMIC. fired car up, no idle. changed MAF 1&2 calibration tables for 4" intake found in this form, able to idle, will not rev up past 2000 rpm. Also DTC's P0101 and P0234 stored. Using Versatuner. Any help is greatly appreciated!

 

You need a tune for the mods

 

I believe that's what he's trying to do in versatune.
moved to the tuning section

 

Any help on getting a base tune for the mods?

 

Are you trying to self tune?

 

https://mazdaspeeds.org/index.php?threads/versatune-big-turbo-basemap.4533/
A good place to start. I do hope you have the Versatuner full version because you must have it to do all the tables that will need to changed. And spend many hours researching here and everywhere to get up to speed.
Definitely better in long run to get it professionally done.
Be very careful with the modifications and stock rods.

 

there's also this maf cal table
https://mazdaspeeds.org/index.php?threads/mafcals-for-bigger-intakes.10280/

 

Wealth of knowledge here too. Definitely look all over, lots of good information on your concerns.
https://www.versatune.net/forum/viewforum.php?f=13

 

Your MAF calibration is totally off for your intake. It's easy, desired lambda 0.98, actual lambda 0.65, that's almost 35% off.