Hi, im new here. not finding much help on the internet, its like 100 degrees out, which means i havent crawled under it yet.... so i figured it...
7 months ago I had a very trusted and reputable performance shop install a clutch on my speed3, I went with the classic Luk+Fidenza combo, well...
Hey guys, First off I'd like to apologize if this forums is in the wrong thread. My 08 speed lost clutch pressure one day as I was driving. so I...
I’m looking for some advice… I’ve got a 2008 MS3 with relatively low mileage for its age (86,000). I’m the original owner, I’ve taken good care...
Hey all, I'm creating this thread to share the symptoms, diagnoses and solutions I found when my clutch pedal feel and clutch biting point started...
Hi guys this is my first post, I just bought a msp6 a few months ago and it had a stage 3 ACT clutch and flywheel on it along with a new motor...
New member, just picked up a 2012 Speed 3 a few months ago. Just a bit of background- I learned stick maybe 10 years ago but this is my first...
[IMG] So I’ve ran into a problem. I was bleeding slave cylinder and not my clutch pedal bracket broke up from the the clutch pedal. Is there...
UPDATE: 4/2020 After using this for a while it appears that the speed 6 bore is not going to work with the speed 3 master cylinder. It creates too...
I recently went built motor and installed an ACT 6 puck "zx5-hdg6 kit". The first 1500 miles or so the clutch engagement was about 3/4 up the...
Hey folks, I have a 2012 Speed3 that I picked up as a CPO. Bought at 33k, now at 52k. Recently the clutch has been grabbing all the way at the...
Separate names with a comma.
